|
【范围】
|
This test plan consists of two major sections for the production testing of bus controllers: Electrical tests
and Protocol tests.
1.1 General: This production test plan defines the test requirements for determining that bus controllers
meet the requirements of MIL-STD-1553B, "Digital Time Division Command/Response Multiplex Data
Bus."
1.2 Application: This is a general test plan for any bus controller designed to meet the requirements of MIL-
STD-1553B. These requirements shall apply to the bus controller under test, when invoked in a
specification or statement of work.
The primary intent of this test plan is to test those requirements of MIL-STD-1553 for bus controllers that
have been implemented in hardware, software, or firmware. However, it is recognized that some
additional software may be required to meet this intent and that this software may be the operational
software (or some portion thereof), special test software, or some combination of these.
Tests specified may be performed in any order, combined with one another, or combined with other tests
of the subsystem in which the bus controller may be embedded.
The bus controller which is under test must also have had its design validated per the "Validation Test
Plan for the Digital Time Division Command/Response Multiplex Data Bus Bus Controllers."
This document deals only with bus controller functions which are explicitly described in MIL-STD-1553B.
This document does not specify tests that check the integrity of data from the subsystem to the bus, nor
does it attempt to address the system test requirements.
Special requirements such as those needed to meet armament bus requirements when specified in the
individual equipment specification may, when within 1553B requirements, replace values or tolerances
specified in this test plan for the purpose of generating a UUT production test procedure.strRefField
|